KIPP Washers / Collars / Sleeves (Metal)

· High temperature resistance

· Steel, stainless steel A2 or stainless steel A4

Product description: The Hygienic DESIGN spacer was specially developed for use in food-processing facilities. The distance between two components can be infinitely adjusted to the required length using a spanner. Special emphasis has been placed on the cleaning-optimised geometry and a surface finish of Ra ≤ 0.8 μm. The sealing washer made from foodstuff conform plastic is exchangeable. Material: Spacer: stainless steel 1.4404. Sealing washer: EU10/2011 and FDA conform thermoplastic (POM). Shaft seal: 75 EPDM 295. Version: Spacer: unpolished stainless steel. Sealing washer: RAL5002 - Ultramarine blue (POM). Shaft seal: 75 EPDM 295 - black. Note: The contact face for the sealing washer must ideally be flat and perpendicular to the threaded hole and have a surface finish of Ra ≤ 0.8 μm. Sealing ring is unsuitable for acidic cleaning (pH < 4) and oxidising agents. The suitability of the Hygienic DESIGN spacer sleeves for the respective application must be checked by the user. Depending on the loads and external influences (temperature, cleaning media, product media), the sealing washer should be inspected regularly and replaced if necessary. Temperature range: -20 °C to +100 °C (POM). Advantages: Infinitely adjustable spacing. Exchangeable sealing washer. Foodstuff conform material. Cleaning optimised geometry. On request: Special lengths. Accessory: Sealing washer K1649. Ring/open-end spanner with protective caps K1362. Hexagon bolt K1647.

· Ground height dimension· Increased strength

· Increased strength· For increased strength requirements

· Stainless steel 1.4404· Size M6–M12· exchangable seal washer· Foodstuff conform material· Cleaning optimised geometry

· The integrated bearing unit can achieve twice the clamping force with the same lever length· The component surface is protected by the stationary lower ring· Higher preload force results in a lower tendency towards material relaxation in the thread

· To compensate for unevenness· Version: steel or stainless steel

· To change the diameter between the hollow shaft sensor and adjustment spindle

· High load rating · Diverse application possibilities

Material: Stainless steel 1.4305. Version: Bright.

· To compensate for unevenness· Version: steel or stainless steel

· Can be dismantled without completely removing the screws· Captive

· Can be dismantled without completely removing the screws

· Quick and easy actuation· Tempered

· Accessories for round pull handles· Stainless steel A4 quality

Product description: The washer can be fitted between the thrust washer and the contact face. Material: Stainless steel 1.4305. Version: Bright.